Working today, stopped for lunch, test fit, sharp parts

Well after a lot of work the starter hits the oil pan, so now to look at smaller starters.

Starting the intake manifold today, making the water cross over first, here is the material for job

Hi, starter now fits, had to grind the side of the starter, and the side of the oil pan, also I have to move 2 bolt holes over about 1/8", I think I can do this with a Heli Coil, the engine cranks over fine.
Now back to the intake manifold

Really hope it fits to the dragster frame! Tight spots….

 Seppo from Järvenpää, Finland
www.hollowheads.net (just click the hole in the head to proceed)

That’s an Ouch!

Lorena, Texas (South of Waco)

I measured twice, should have at least 1/4" at the tightest point (I hope)

Motor plate done (may paint it one more time)

Cliff, there are much easier ways to obtain red paint..................






 


64F100 57FAIRLANE500

I know, after working on parts, I need to test fit before finishing (sharp on the edges).