Group: Forum Members
Last Active: 6 Years Ago
Posts: 733,
Visits: 3.8K
|
Here is a photo of my original stock 57 Tbird spring standing next to the CC850 Aerostar spring from Rockauto. The standing free height difference is substantial. Is this what others have found? I thought I had cut the original springs but looking them over I didn't when I replaced them 7(?) years ago. Any comments will help. Don't want to make a mistake putting this on with the Granada spindles.
57 Black Tbird 312/auto
|
Group: Forum Members
Last Active: 2 Years Ago
Posts: 1.1K,
Visits: 58.8K
|
MarkMontereyBay (12/13/2012)
Here is a photo of my original stock 57 Tbird spring standing next to the CC850 Aerostar spring from Rockauto. The standing free height difference is substantial. Is this what others have found? I thought I had cut the original springs but looking them over I didn't when I replaced them 7(?) years ago. Any comments will help. Don't want to make a mistake putting this on with the Granada spindles.  Yes, I just did mine and I can confirm thte difference in height I've got a pic almost like yours just to prove it. Mine dropped about 2.
A L A N F R A K E S ~ Tulsa, OK
|
Group: Forum Members
Last Active: 6 Years Ago
Posts: 733,
Visits: 3.8K
|
Back at work on the Tbird disc brake swap. Have everything in place; Granada front spindles and rotors/calipers, Aerostar springs, dual manual master cylinder, Wilwood prop valve, battery relocated, etc. Just have to bleed the brakes and see if it all works tomorrow morning. Does anyone have a source for rear axle lowering blocks/U Bolts?. Also I trimmed the front lower A arm frame bumpers but would like to find an aftermarket set that could do a better looking job.
57 Black Tbird 312/auto
|
Group: Forum Members
Last Active: Yesterday
Posts: 4.6K,
Visits: 37.6K
|
Go to Speedway and pay less. Chuck
Y's guys rule! Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.
  MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi) Manchester, New Hampshire
|
Group: Forum Members
Last Active: 6 Years Ago
Posts: 733,
Visits: 3.8K
|
Speedway has what I want. I always try to get stuff from Summit. It is always on the front porch the next day after I order but they didn't show much this time. There warehouse is in Reno, so very quick shipping to me here. I will order from Speedway but takes much longer. Thanks.
57 Black Tbird 312/auto
|
Group: Forum Members
Last Active: 6 Years Ago
Posts: 733,
Visits: 3.8K
|
Got the brakes bled...finally and now have brakes indeed. Backed it out of the garage then up and down the driveway to make sure no disasters were pending. Due to the Aerostar springs and the drop using the Granada spindles it is low in the front. Had a penguin stance though and spent the afternoon re-setting the alignment. Took it out on the road and it stops just fine without power brakes, very nice. Not so good getting into the driveway or turns. Too low...Aerostar springs are coming out and the original springs I had in it going back in for test drive number two.
57 Black Tbird 312/auto
|
Group: Forum Members
Last Active: 3 Months Ago
Posts: 612,
Visits: 6.5K
|
Mark
Did you take any pictures of the car before you removed the aero springs? Would you take some "after" you get the orgional springs in and post them? I would love to see how low "too low" is.
Gary Ryan San Antonio.TX.
|