We do have one set of copper gaskets, but we opted to test what Fel-Pros really can stand . Now we know. For the next season there will be proper O-rings and boost will be added up to 2.5 bar... Maybe?

 Seppo from Järvenpää, Finland
www.hollowheads.net (just click the hole in the head to proceed)

Can't you guys get a solid copper gasket?

   God Bless.   Tim                           http://yblockguy.com/

350ci Y-Block FED "Elwood", 301ci Y-Block Unibody LSR "Jake", 312ci Y-Block '58 F-100, 338ci Y-Block powered Model A Tudor

tim@yblockguy.com  Visalia, California    Just west of the Sequoias

Jep, I did a quick autopsy again and cylinder #3 was full of water and a head gasket was done .

And someone had changed engine oils to Bailey's irish Cream liquor .

Our fans at the garage were all little disappointed about our progress...

Five runs during the weekend: 9.483 / 219.35 km/h, 9.571 / 217.80 km/h, 9.665 / 216.21 km/h, 9.268 / 238.65 km/h and then that 8.723 / 241.84 km/h.

0.757 to WR .

 Seppo from Järvenpää, Finland
www.hollowheads.net (just click the hole in the head to proceed)

WOW! Very cool guys!

bla bla bla

   God Bless.   Tim                           http://yblockguy.com/

350ci Y-Block FED "Elwood", 301ci Y-Block Unibody LSR "Jake", 312ci Y-Block '58 F-100, 338ci Y-Block powered Model A Tudor

tim@yblockguy.com  Visalia, California    Just west of the Sequoias

WOW!!!!!!!!  Way to go!!!!!!!!!!!!!

Mike

I'd rather be lucky than good.................

    but good ain't bad!!

Really outstanding progress, if you look at the RT you will see that there is you reason for the loss. You guys should be very happy with that run, wheels up and all.

Gary Ryan San Antonio.TX.

8.72 and close to 145-150, too cool. That equates to around 500-550 hp at the wheels...nice. And from a <300 inch powerplant, amazing! Great work guys.


James Potter
`57 Fords International



`57 Custom Tudor

`57 Fords International National Director

Pass Christian, MS (near Gulfport/Biloxi)

Awesome job!! 8.728 @ ~150 mph. Good for you guys, just starting to get dialed in!!

"The Master Cylinder"

Enjoying life at the beach in SOCAL

Pics...  Burn Outs are getting better and better too

7 psi at the rear wheels gets them twisted . Best 60 ft was 1.228 seconds. Not bad?

 Seppo from Järvenpää, Finland
www.hollowheads.net (just click the hole in the head to proceed)

My, My, My.............Now that is fast. Great job guys.

Charlie Burns Laton, Ca (South of Fresno)



BurnsRacing981@gmail.com