|
Group: Forum Members
Last Active: Yesterday
Posts: 3.8K,
Visits: 33.0K
|
Thank You Ted. I will do it that way and finish with 25 foot lb pounds on the Torque wrench.
 
|
|
Group: Administrators
Last Active: 2 days ago
Posts: 7.6K,
Visits: 206.0K
|
By the book, it is 23-28 ft-lbs for the intake manifold bolts for the Ford Y. The 1957 service manual does not specify aluminum or iron for the intake manifold bolts, but I will assume that value is for either. I typically just tighten the intake bolts in steps with a hand wrench or ratchet while paying particular attention to the tightening sequence. For the Ford FE, it’s 25-28 ft-lbs for an aluminum intake and 35 ft-lbs for an iron intake.
  Lorena, Texas (South of Waco)
|
|
Group: Forum Members
Last Active: Yesterday
Posts: 3.8K,
Visits: 33.0K
|
Should I use same Torque on Bolts for my new Aluminum Intake Manifold as used on Factory Cast Iron Manifold? Thanks!
|