• Home
• »
• Keeping The Dream Alive!
• »
• Technical
• »
• 292 Y-Block crank spacer

292 Y-Block crank spacer

Posted By Lawrence Petty 6 Years Ago

You don't have permission to rate!

Post Reply

292 Y-Block crank spacer

View

• Flat Ascending
• Flat Descending
• Threaded

Options

• Subscribe to topic
• Print This Topic
• Goto Topics Forum

Author	Message
Lawrence Petty	Posted 6 Years Ago
Supercharged Group: Forum Members Last Active: 5 Years Ago Posts: 28, Visits: 5.9K	Does anyone have the spacer that goes in front of the oil slinger on the crankshaft ... or know where to buy one
	Reply Quote

Threaded View

Threaded View

292 Y-Block crank spacer By Lawrence Petty ( 6 Years Ago ) I've never seen a spacer on any Y block I've worked on. FE's have them... By 57RancheroJim ( 6 Years Ago ) [quote][b]Lawrence Petty (8/27/2019)[/b][hr] Does anyone have the... By oldcarmark ( 6 Years Ago ) The spacer may be for the 1954 Ford with the 239 without power... By patm ( 6 Years Ago ) Drawing for Y-Block Crankshaft Assembly 1955 - 1962 shows oil slinger... By Lawrence Petty ( 6 Years Ago ) 6700 is the Timing Cover Seal. 6310 is the Oil Slinger. Keeps Oil off... By oldcarmark ( 6 Years Ago ) [quote][b]Lawrence Petty (8/28/2019)[/b][hr] Drawing for Y-Block... By oldcarmark ( 6 Years Ago ) The SPACER you are wondering about (was separate on 1954 EBU 239CI)... By KULTULZ ( 6 Years Ago ) I think Mark answers the question. A spacer would either not move the... By charliemccraney ( 6 Years Ago ) That drawing is misleading and in one place states its a spacer, not a... By Lawrence Petty ( 6 Years Ago ) Let's start over. You know you have a 292. What is it out of, a PASS... By KULTULZ ( 6 Years Ago ) I ran into a similar situation latest year when I built the 292 in my... By Florida_Phil ( 6 Years Ago ) For comparison, here’s a 239 spacer. The 239’s didn’t have a... By pintoplumber ( 6 Years Ago ) Torquing the balancer too tightly will not cause this. It's steel... By charliemccraney ( 6 Years Ago ) Check for the damper hitting the timing cover. By Cliff ( 6 Years Ago ) So what inside dimensions - length should the harmonic balancer have... By Lawrence Petty ( 6 Years Ago ) [QUOTE]That drawing is misleading and in one place states its a... By KULTULZ ( 6 Years Ago )

Post Reply

Back To Top

Reading This Topic