More work, front axle going in, all parts refinished, all grade 8 hardware, bare metal finished with Sharkhide.

Here's what I did today, will install it tomorrow

Installed

Update, working on all small parts, cleaning repairing and refinishing (long time), I am replacing the gas tank going from 2 1/2 gal to 4 gal, however it won't fit the car, so some more work, added a bushing to the steering rod, was metal to metal before.

More work, this work is slow, front wheels installed, cleaned all parts, new seals, fit gas tank (hard job), refinished the mount for the shifter,, started rebuilding the shifter.

Going home

Shifter done and installed, the solenoid was a hard job (finished with Sharkhide) 

Working today, new stainless brake line (20ft) routes through the frame (hard to do), master cylinder cleaned, painted and installed, new brake push rod made (stainless) the old one was a pipe, with nuts welded on each end (poor work), reworking the brake pedal. 

Now the dash, this thing is CRAP, I'm going to make a new one, the wire loom looks like the phone wires in my house. so all will be new.

Short note, started to make the dash, this is cut out of an old off road race truck part (carbon fiber), switch plate mocked up, switches used to be mounted in the dash.

I have to ask what are the tubes sticking out of the front of the dragster frame?



Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire