Author
|
Message
|
56_Fairlane
|
|
Group: Forum Members
Last Active: 2 Years Ago
Posts: 575,
Visits: 14.6K
|
I just take the air cleaner lid off mine and pour a little gas down the carb if my Fairlane has sat a while. I'll even use a little 2-stroke mix if it sat more than a month. I don't pump it nor even touch the pedal when cranking it. I'll just hit the pedal once before turning the key to set the choke after pouring the gas. It starts almost instantly but stumbles just a little before the carb fills and then smooths out. Once it's idling the air cleaner goes back on.
~DJ~ AKA "Bleach" 1956 Ford Fairlane Town Sedan 30K original miles
|
|
|
pinchsplat
|
|
Hitting on all eight cylinders
Group: Forum Members
Last Active: 6 Years Ago
Posts: 4,
Visits: 6
|
thanks charlie,good to know. seems I would be wasting time and money with carb conversion/update.
|
|
|
charliemccraney
|
|
Group: Moderators
Last Active: 6 hours ago
Posts: 6.1K,
Visits: 437.5K
|
Mine usually requires a bit different technique after several days even with a modern carb and electric pump. It seems like the accelerator pump also has to fill and doesn't really do it until I give it a couple pumps of the pedal. Otherwise, it typically starts with just a bump of the starter.
Lawrenceville, GA
|
|
|
pinchsplat
|
|
Hitting on all eight cylinders
Group: Forum Members
Last Active: 6 Years Ago
Posts: 4,
Visits: 6
|
A few more pedal pumps may be necessary,and yes the choke closes when cold,and good choke break when started.Thanks for the tips guys.
|
|
|
PF Arcand
|
|
Group: Forum Members
Last Active: 8 Months Ago
Posts: 3.3K,
Visits: 238.8K
|
Is the choke closing properly & the pull off kicking open as it starts?. For instance, some carbs such as Quadrajets can take 4 or 5 pumps to the floor after sitting for a substantial perod in the cold, before they will start..
Paul
|
|
|
MoonShadow
|
|
Group: Forum Members
Last Active: 12 minutes ago
Posts: 4.5K,
Visits: 37.1K
|
Do you let the pump run a while to fill the carb bowls?
Y's guys rule! Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.
MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi) Manchester, New Hampshire
|
|
|
pinchsplat
|
|
Hitting on all eight cylinders
Group: Forum Members
Last Active: 6 Years Ago
Posts: 4,
Visits: 6
|
good advice Moonshadow,however that has already been tee`d in,along with a Pertronic system, carb has been gone thru,new Battery,cables,etc.runs great and re-starts easily after initial cold start.
|
|
|
MoonShadow
|
|
Group: Forum Members
Last Active: 12 minutes ago
Posts: 4.5K,
Visits: 37.1K
|
An electric in line fuel pump to fill the bowls prior to starting will cure this.
Y's guys rule! Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.
MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi) Manchester, New Hampshire
|
|
|
pinchsplat
|
Posted 6 Years Ago
|
Hitting on all eight cylinders
Group: Forum Members
Last Active: 6 Years Ago
Posts: 4,
Visits: 6
|
ANYONE RECOMMEND A SUITABLE CARBURETOR CONVERSION,4BBL, TO HELP ALLEVIATE HARD STARTING AFTER A 7, OR MORE DAYS,SITTING.OTHERWISE VEHICLE RUNS AND PERFORMS BEAUTIFULLY.
|
|
|