I'm looking for a drive snout for a B&M 177 blower. Anybody got a local source for used parts or one hiding under a bench somewhere? Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

Hey Hey! I thought that pic of your engine with Randy's blower might get you thinking.

Glen Henderson



Freedom is not Free

Letohatchee, AL

I went a little blower crazy after that. Now have a B&M thats missing the snout, a complete 4-71 street blower and a 6V-71. The 6V-71 isn't commonly used because the case is rounder at the bottom and uses angled bolts to fasten. No one is making intake or carb adapters for them. I've got a deal working for a intake so I'll spend the winter playing with blower parts. Intent would be to run at least the 4-71 on the new Eaton motor in the roadster! We'll see how that pans out. Isn't it funny how a picture will drive you to madness? Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

Give Jerry C a call, no telling what he has stuck back in the "Skunk Works".

Glen Henderson



Freedom is not Free

Letohatchee, AL

Good idea! I hadn't thought of that. Jerry has pieces of almost everythin around his place. Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

Chuck would you need to have length of snout in mind before you buy one.

  AussieBill            YYYY    Forever Y Block     YYYY

 Down Under, Australia

The B&M/Weiand/Holley 177 long snout is what I was looking for. Thats whats on Randy's motor. Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

Chuck:

You might try a scrub site.  Some of those guys have a lot of broken parts.

John - "The Hoosier Hurricane"

I've been looking but they think the units are gold plated. You can buy a new setup for about $2500 and I've seen drives for over $1000! These guys are nuts. I did pick up another B&M 177 this one is complete so I'm gaining on it. Now I have to work on the manifold issue. Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire