Now that I have sold a car I have the money to build the 292 and need to know if there are any machine shops in or around Ohio that really knows Y blocks and what to do to them,I am not going to use any local machine shops since they probably have not worked on any in years. I talked to a local who is a well know racer who builds motors and he admitted its been over 20 years since he built one so I want someone who has recently worked on one,I used a local cheap shop with the 235 I have in my 37 Chevy p/u and it needs to come apart due to something not right.

Butchering up everything I can get my hands on in Dayton Ohio

Check out Canton Automotive Machine Shop (CAMS) in Canton, Ohio and talk to Roger Decker.

Lorena, Texas (South of Waco)

Ted,

       I was going to say that! Roger builds and has built Fords for the best part of 40 years. 90% of the race motors in northeastern Ohio come from his shop. How do I know? I grew up in the Canton area.

     Also, maybe a little closer to your part of Ohio would be Harry Hutten, He has a shop in the Cinnci area.  

Frank/Rebop

Bristol, In ( by Elkhart) 

another good one is Gellner Engineering in Cleveland. Talk to Dean or Sam Gellner, tell them Stan from Allega Cement sent you. Great guys!

I was hoping one would be a little closer to Dayton but since I dont trust too many around here it might be worth the trip.

Butchering up everything I can get my hands on in Dayton Ohio

I forgot about Harry Hutten and will have to look him up,I think I know where his shop is and check him out in a couple weeks when I am on vacation.

Butchering up everything I can get my hands on in Dayton Ohio

Harry is just outside of Cincinnati. I'm sure he could be a great help. He should be lurking here someplace. I think he's hhutten40 on the forum.  Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire