This is just some of the stuff that I have gathered up to take to Columbus, so bring cash or check. I don't want to bring any of it back. Not pictured are a couple of blocks, 57 hoods and deck lid and maybe a complete 292. I am still digging up stuff, so if you see something that you want more info on send me a message or call (334) 227-3004. All proceeds will go to fund the falcon project. Thanks, Glen

Glen Henderson



Freedom is not Free

Letohatchee, AL

Glen, Is there a set of skinny slot mags in that pile? Chuck in NH

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

BRING it ON !!! And bring it to Columbus .The Aussie $ is buying about 90 cents US right now , so it's good to  be shopping for car parts .Don't forget to bring ALL those good Y-Block parts with you .

Lon

yblocksdownunder

No Chuck they are not skinny's (would not be for sale if they were) but a decent set of 4 with pretty good rubber. They are 14 X 7 or 8, never broke them down to measure. Also in the pile are two 14 X 8 new chrome reverse with very little backspace, Other good stuff;

G heads

C heads

C1TE crank

312 crank

C1AE rods

312 + .060 block, rods and pistons

292 block

3 ea 57 hoods

57 fairlane deck lid

Granada spindles

Torino spindles

57 factory A/C vents

57 P/S system (core parts only)

and the list goes  on and on and on, I didn't know that I had so much stuff. I am still digging and I'm sure that I have more to add. By the way all the S/C stuff is already sold to Chuck.

Glen Henderson



Freedom is not Free

Letohatchee, AL

I see a jack! I'm looking for one for my 56 Fairlane, any luck?

Ol'ford nutCentral Iowa

56 Vic w/292 & 4 spd.

Glen, do you have a good deck lid for a 57 ford custom? gary

-Gary Burnette-

That is an orginal 57 jack complete with base plate, lug wrench and the j bolt in excellant unrestored condition. I had planned on getting Tom to give me an apprasial before I put a price on it, but I will listen to offers.

Gary the only good deck lid that I have is for a fairlane. I have one for a custom that has a little bubbling and is slightly bent on the left corner, I think it can be repaired with out too much work. If you are interested let me know and I will through it on the wagon, you can look at it and make up your on mind as to condition.

Glen Henderson



Freedom is not Free

Letohatchee, AL

glen will those torino spindles fit a 55 or 57 ? if so  send me a price on those and the granada ones  

y-block newbie

Don, I have never used the Torino spindles, but they are supposed to fit without reaming the balljoint hole and they retain stock ride height, $100. The Granada's reguire reaming the balljoint and lower the front 1" to 2", these that I have look rough (the car sat on the dirt for a long time. They will clean up, but the rotors and calipers are junk good for cores only. $100

Glen Henderson



Freedom is not Free

Letohatchee, AL

OK Glen, I'll check the 57 custom deck lid in Columbus then and we can go from there. Thanks gary

-Gary Burnette-