|
Group: Forum Members
Last Active: 3 hours ago
Posts: 2.0K,
Visits: 119.0K
|
https://vimeo.com/401130048
Daniel JessupLancaster, California aka "The Hot Rod Reverend" 
check out the 1955 Ford Fairlane build at www.hotrodreverend.com
|
|
Group: Forum Members
Last Active: 2 Months Ago
Posts: 464,
Visits: 183.3K
|
Why didn't you braze it? Easier/Better!
"FREE SAMPLE"
|
|
Group: Forum Members
Last Active: 3 hours ago
Posts: 2.0K,
Visits: 119.0K
|
Lord Gaga (3/27/2020)
Why didn't you braze it? Easier/Better! Never have brazed anything, not that I don't think I could handle it. I didn't have any brazing stock, and I only have a propane torch - not that you can't braze with a propane torch but the OA I'm sure would be much better. Work with what you got I suppose.
Daniel JessupLancaster, California aka "The Hot Rod Reverend"
check out the 1955 Ford Fairlane build at www.hotrodreverend.com
|
|
Group: Forum Members
Last Active: Last Year
Posts: 216,
Visits: 106.5K
|
I brazed a couple I had. It came out nice as the brass really flowed and sealed it up as well. I honestly have not done much brass soldering, but the trick to soldering is that the solder(brass) goes to the heat. So heat the area you want the solder to go and it flows into those spots.
Pat Fleischman
|
|
Group: Forum Members
Last Active: 3 hours ago
Posts: 2.0K,
Visits: 119.0K
|
I reckon I will have to try that route sometime. At any rate, this oil fill tube will not be coming off this pan anytime soon!
Daniel JessupLancaster, California aka "The Hot Rod Reverend"
check out the 1955 Ford Fairlane build at www.hotrodreverend.com
|
|
Group: Forum Members
Last Active: 3 hours ago
Posts: 2.0K,
Visits: 119.0K
|
Here is the video of the overall fit...
Daniel JessupLancaster, California aka "The Hot Rod Reverend"
check out the 1955 Ford Fairlane build at www.hotrodreverend.com
|