Oil pump drive shaft washer

Posted By 55 GLASS TOP 5 Years Ago

You don't have permission to rate!

Oil pump drive shaft washer

Author	Message
55 GLASS TOP	Posted 5 Years Ago
Supercharged Group: Forum Members Last Active: 2 Years Ago Posts: 389, Visits: 31.8K	Hello when I put my oil pump in I put the washer on the bottom near the pump , I was just told the shaft is inserted from the bottom with the washer on top. Can some one point ME in the right direction . Thanks
	Reply Quote

Threaded View

Oil pump drive shaft washer By 55 GLASS TOP ( 5 Years Ago )

The washer goes on the oil pump end. The shaft is installed from the... By charliemccraney ( 5 Years Ago )

That is where I put it ,but I was told I was wrong By 55 GLASS TOP ( 5 Years Ago )

They person who told you that is wrong [quote][b]55 GLASS TOP... By paul2748 ( 5 Years Ago )

Thanks everyone my confidence has been renewed By 55 GLASS TOP ( 5 Years Ago )

Has anyone had one come out of the distributor? I have a ARP oil... By panel driver ( 5 Years Ago )

I wouldn't remove it, thats what prevents the shaft from coming out... By 57RancheroJim ( 5 Years Ago )

In the normal course of running the engine, the intermediate drive... By Ted ( 5 Years Ago )

OK, I am confused now. I always install the star washer next to the... By Joe-JDC ( 5 Years Ago )

Assuming you installed the shaft from the oil pump side and the washer... By 57RancheroJim ( 5 Years Ago )

Ok, someone needs to clarify terminology. The distributor/oil pump... By Joe-JDC ( 5 Years Ago )

So let me see if I have this right , let’s assume the 292 is attached... By 55 GLASS TOP ( 5 Years Ago )

Depends on which Washer You have. Too big to go into Block means it... By oldcarmark ( 5 Years Ago )

I said it correct. The star washer fits on the distributor end. It... By Joe-JDC ( 5 Years Ago )

[quote][b]Joe-JDC (3/1/2020)[/b][hr] I said it correct. The star... By oldcarmark ( 5 Years Ago )

So we are saying the 5/8 washer goes on the upper end of the oil pump... By panel driver ( 5 Years Ago )

RE: Oil pump drive shaft washer By 55 GLASS TOP ( 5 Years Ago )

As long as the washer is between the block and the oil pump, you are... By paul2748 ( 5 Years Ago )

boy i am loving this so much! how much fun can you have with a... By blocky ( 5 Years Ago )

It just goes to show you it’s the little things in life that count By 55 GLASS TOP ( 5 Years Ago )

When I rebuilt my TBird engine, I used an ARP oil pump drive shaft.... By Florida_Phil ( 5 Years Ago )

RE: Oil pump drive shaft washer By 55 GLASS TOP ( 5 Years Ago )

Folks, you are messing up with the pictures. That star washer fits... By Joe-JDC ( 5 Years Ago )

[quote][b]Joe-JDC (3/1/2020)[/b][hr] Folks, you are messing up... By 57RancheroJim ( 5 Years Ago )

Panel driver asked if anyone had the shaft pull out with the... By Hoosier Hurricane ( 5 Years Ago )

Boy this subject has become a real monster.......... By 55 GLASS TOP ( 5 Years Ago )

How did something so simple suddenly turn into rocket science?... By Ted ( 5 Years Ago )

i always found the fe engines to be the worst for droping the shaft.a... By darrell ( 5 Years Ago )

More clarification. By Ted ( 5 Years Ago )

The first time I dropped an oil pump shaft in the pan was a night... By Florida_Phil ( 5 Years Ago )

The last 5 Y blocks I have torn down had the star washer in the wrong... By Joe-JDC ( 5 Years Ago )

In defense of everyone on this thread, I think everyone is correct. At... By FORD DEARBORN ( 5 Years Ago )

[quote]At least 2 different styles of intermediate shafts, one same... By KULTULZ ( 5 Years Ago )

HOLY COW different lengths a new piece of the puzzle By 55 GLASS TOP ( 5 Years Ago )

RE: Oil pump drive shaft washer By tbirddragracer ( 5 Years Ago )

Nice! Looks familiar. :) By Florida_Phil ( 5 Years Ago )

[quote] In measuring a ARP shaft I have sitting here, the diameter at... By KULTULZ ( 5 Years Ago )

[quote][b]KULTULZ (3/5/2020)[/b][hr]TED, Any chance of getting the... By Ted ( 5 Years Ago )

[quote] The two ARP shafts I have sitting here both measure 8.070”... By KULTULZ ( 5 Years Ago )

tbirddragracer, Ernie, that black 57 bird is the nicest one I have... By 30 coupe ( 5 Years Ago )

According to the info in the link below, it was a change during 60/61.... By charliemccraney ( 5 Years Ago )

[quote]According to the info in the link below, it was a change... By KULTULZ ( 5 Years Ago )

Bad, K. But you always make me smile. By miker ( 5 Years Ago )

[quote]Bad, K. But you always make me smile. [/quote] I have the... By KULTULZ ( 5 Years Ago )

The ARP shaft that I purchased did not have a washer. This surprised... By Florida_Phil ( 5 Years Ago )

Hmmmm, grown men “comparing shaft lengths” sounds a bit strange By 55 GLASS TOP ( 5 Years Ago )

[quote]So having a too short intermediate shaft will have no... By Florida_Phil ( 5 Years Ago )

[quote]By being a bit too long he trimmed the pump end to make it fit... By KULTULZ ( 5 Years Ago )

No hate here, just great we can share all this information for the... By FORD DEARBORN ( 5 Years Ago )

After visually checking the block housing, there is a step in the oil... By Joe-JDC ( 5 Years Ago )

Very good information as to how the star washer is designed to work at... By FORD DEARBORN ( 5 Years Ago )

[quote]Would be interesting to know if the ARP, with it's larger mid... By Florida_Phil ( 5 Years Ago )

Thanks for the "yes" answer and response - I agree............. By FORD DEARBORN ( 5 Years Ago )

[quote] As long as the pump turns without binding and the shaft can't... By KULTULZ ( 5 Years Ago )

[quote]... grown men “comparing shaft lengths” sounds a bit strange... By KULTULZ ( 5 Years Ago )

Florida_Phil seems to have the best scenario. The mid section (ARP... By FORD DEARBORN ( 5 Years Ago )

[/quote] Florida_Phil seems to have the best scenario. The... By marvh ( 5 Years Ago )

[quote]I may hold you to your offer from a couple years ago for that... By KULTULZ ( 5 Years Ago )

[quote]There was also a problem with some blocks especially when... By KULTULZ ( 5 Years Ago )

My confusion continues. Did they make different diameter mid sections... By 57RancheroJim ( 5 Years Ago )

In measuring a ARP shaft I have sitting here, the diameter at its... By Ted ( 5 Years Ago )

[quote][b]Ted (3/5/2020)[/b][hr] In measuring a ARP shaft I have... By 57RancheroJim ( 5 Years Ago )

ARP shaft 0.370" - Thanks. By FORD DEARBORN ( 5 Years Ago )

Ad nauseam is a Latin term for argument or other... By Lord Gaga ( 5 Years Ago )

7 Pages for a washer has to be a record By 55 GLASS TOP ( 5 Years Ago )

[quote]7 Pages for a washer has to be a record [/quote] It is not a... By KULTULZ ( 5 Years Ago )

it started as a washer and went everywhere By 55 GLASS TOP ( 5 Years Ago )

I found this post slightly informative but incredibly entertaining.🤨 By ian57tbird ( 5 Years Ago )

I just threw up in my mouth! PLEASE STOP! By Lord Gaga ( 5 Years Ago )

Post Reply

Reading This Topic