looking for a cam retaining plate;AN OIL SLINGER :and the nut that goes into the oil pump for the oil pickup tube
thanks 

The cam retaining plate needs to be thinner than the thrust washer you have.  Measure it.  You will need a caliper or micrometer.  A tape measure or similar will not work.
Or, look for a matched set.


Lawrenceville, GA

Where are you at?

Lorena, Texas (South of Waco)

hi ted  I am in N.J. if you have the parts sell let me know and I will call you 
thanks ken

 I have those three pieces.  It would be nice to know the thickness of the cam thrust washer you have so that the appropriate cam thrust plate can be supplied.  Email me the thickness of the washer and your mailing address and I’ll send you the cam thrust plate, the oil slinger, and the oil pump nut.  My contact information is located at www.eatonbalancing.com .

Lorena, Texas (South of Waco)

thanks ted the beveled thrust washer is 194 my worn cam plate is188 I also need if you have
the crank bolt&washer&distribuitor hold down clamp my info is
ken piscitelli 
9 canal st Sayreville n.j. 08872  732/407/9825

emt - I have a couple of distributor hold down clamps.  Can send you one.  I'm going to out of town from the 13 to the 20th

Let me know.



54 Victoria 312;  48 Ford Conv 302, 56 Bird 312
Forever Ford
Midland Park, NJ

Ken.  I also have the distributor hold down clamp and harmonic damper bolt/washer.  I’ll include those with the other three pieces.  I’ll try to get them packaged up today and on their way to you.  Otherwise they will ship out on Monday for sure.

Lorena, Texas (South of Waco)

ted thanks again your a big help received the parts today

thanks but ted bailed me out