Group: Forum Members
Last Active: Last Year
Posts: 257,
Visits: 3.9K
|
Folks, I've tried searching for the info., but unable to find it so far (poor internet connection here): I'm looking for the information on how to "modify" the spin-on oil filter adapter plate to eliminate leaks around outer edge (somehow "spring" it out more); as mine on my newly rebuilt and now installed motor had a leak when out of the car, was "fixed" and now again leaks in the car. I need to now crawl under, remove, "fix" (again), and re-install (now in unheated shelter in northern MN [COLD!!!!]). Can someone provide the link or direct info. in this regard? Thanks & regards, JLB
55 Ford Crown Victoria Steel Top
|
Group: Administrators
Last Active: 2 Weeks Ago
Posts: 7.4K,
Visits: 205.0K
|
|
Group: Forum Members
Last Active: Last Year
Posts: 927,
Visits: 190.0K
|
i used teds fix,but also dried holes opeset slot to even the presure on cold starts. some concerns re oil drain back when engine stopped,well i use fram filters that have a built in check. when plate is straight the filter if tight should help the seal on adaptor. i also glued adaptor seal to adaptor.
|
Group: Forum Members
Last Active: Yesterday
Posts: 863,
Visits: 13.3K
|
Take it apart, install the gasket dry no sealant.
|
Group: Forum Members
Last Active: 3 hours ago
Posts: 3.7K,
Visits: 32.4K
|
|
Group: Forum Members
Last Active: Last Year
Posts: 1.7K,
Visits: 340.0K
|
Is it an original Ford or an aftermarket?...... I read about aftermarket leaking and found an original on Sleez-bay and it has never leaked.
56 Vic, B'Ville 200 MPH Club Member, So Cal.
|
Group: Forum Members
Last Active: Last Month
Posts: 453,
Visits: 22.1K
|
you can do everything right and they can still leak.i must have put on about 6 and half leaked.if at first you dont suceed try again.
|
Group: Forum Members
Last Active: Last Year
Posts: 257,
Visits: 3.9K
|
Thanks everyone. The info. I was looking for was mainly what Ted posted; the other info is also helpful! Regards, JLB
55 Ford Crown Victoria Steel Top
|
Group: Forum Members
Last Active: Last Year
Posts: 257,
Visits: 3.9K
|
Thanks everyone. The info. I was looking for was mainly what Ted posted; the other info is also helpful! Regards, JLB
55 Ford Crown Victoria Steel Top
|
Group: Forum Members
Last Active: Yesterday
Posts: 3.6K,
Visits: 497.5K
|
After two of the adapters leaked, I went back to the canister. No more leaks
54 Victoria 312; 48 Ford Conv 302, 56 Bird 312 Forever Ford Midland Park, NJ
|