Profile Picture

Timing

Posted By Pops57 9 Years Ago
You don't have permission to rate!

Timing

Author
Message
Pops57
Posted 9 Years Ago
View Quick Profile
Normally aspirated

Normally aspirated (38 reputation)Normally aspirated (38 reputation)Normally aspirated (38 reputation)Normally aspirated (38 reputation)Normally aspirated (38 reputation)Normally aspirated (38 reputation)Normally aspirated (38 reputation)Normally aspirated (38 reputation)Normally aspirated (38 reputation)

Group: Forum Members
Last Active: 8 Years Ago
Posts: 17, Visits: 67
Hello y block fans, first post here my names Jesse. I have a 1957 ford fairlane 500 292yblock and I love her. She runs and drives. Started doing some maintenance and noticed some stuffs just not right.im not the best mechanic but I take my time very persistent and organized, and like shit done right the first time. So here it is.
Vacuum gauge hooked up to fuel pump to intake line Rapids bounces at 19-20
Gauge hooked up wipers line same thing bounces 19-20
The dizzy to carb line steady 15

When balancer is 0 degrees dizzy rotor is not pointing at #1

Threaded View

Threaded View
Forum Post Timing By Pops57 ( 9 Years Ago )
Forum Post Any help is greatly appreciated.thank you in advance By Pops57 ( 9 Years Ago )
Forum Post Well Im not sure about the vacuum at the fuel pump , sounds like that... By Talkwrench ( 9 Years Ago )
Forum Post Wipers work good. Shouldn't the gauge be a steady reading of 16-20 it... By Pops57 ( 9 Years Ago )
Forum Post Balancers have been known to rotate. If the both valves on #1 are... By paul2748 ( 9 Years Ago )
Forum Post That's how I find it.although when the intake closes the piston comes... By Pops57 ( 9 Years Ago )
Forum Post Weird thing is that it runs pretty good By Pops57 ( 9 Years Ago )
Forum Post The damping mass slips on the damper. Since the timing marks are on... By charliemccraney ( 9 Years Ago )
Forum Post Wipers work good - great . Shouldn't the gauge be a steady reading... By Talkwrench ( 9 Years Ago )
Forum Post So I ran a compression test today.what should I do next as #2 is... By Pops57 ( 9 Years Ago )
Forum Post I'd pull that valve cover, and see if #2 has the valves visibly... By miker ( 9 Years Ago )
Forum Post I've had it off and they all move valve lash is .019 .As I was pulling... By Pops57 ( 9 Years Ago )
Forum Post How do I perform a leak down test By Pops57 ( 9 Years Ago )
Forum Post [quote][b]Pops57 (7/5/2016)[/b][hr] How do I perform a leak down... By Ted ( 9 Years Ago )
Forum Post Opened her up and found #2 cylinder pushrod was out. That would cause... By Pops57 ( 9 Years Ago )
Forum Post [quote][b]Pops57 (7/5/2016)[/b][hr] Opened her up and found #2... By Ted ( 9 Years Ago )
Forum Post A Leak Down Test would help to isolate why the cranking compression... By Ted ( 9 Years Ago )


Reading This Topic

Site Meter