Hi, how did that plexiglass valley hold up to the heat?

That's Moca Mouse.



Lawrenceville, GA

Worked on my 56. Got the wheels painted and most of the brake work finished. Also had to rewire the governor and overdrive solenoid on the T85. I got to ask about that mouse. He was in there when you took a drink? How in the heck did he get in there that soon?

Durham Missouri

Opened it and just had a little before leaving shop and left it on my desk, when I came in the next morning put it in the fridge for later because I hate to waste anything, later that afternoon when I got thirsty decided to finish it, thought it was just settled product on the bottom so tried to lick it out with my tongue, that didn't work so I started rinsing the can out in the bathroom filling with hot water and shaking several times and it wasn't disolving so I turned on the light to see what was going on and thats when I saw clumps of hair in the sink, looked in the can and started gagging, I am still gagging a few days later everytime I think about it!
I don't normally buy drinks of that nature but thought what the heck, I needd an energy boost, maybe it would help. Never again!

55 Vicky & customline

58 Rack Dump, 55 F350 yard truck, 57 F100

59 & 61 P 400's, 58 F100 custom cab, 69 F100, 79 F150, 82 F600 ramp truck, 90 mustang conv 7 up, 94 Mustang, Should I continue?

Plexi glass holds up well but this is not on a driver, its on a test mule for setting up different intakes, carbs etc. I had people mention I should incorporate mini LED lights under it to flash with the ignition!

55 Vicky & customline

58 Rack Dump, 55 F350 yard truck, 57 F100

59 & 61 P 400's, 58 F100 custom cab, 69 F100, 79 F150, 82 F600 ramp truck, 90 mustang conv 7 up, 94 Mustang, Should I continue?

Hi, I am making a intake manifold out of plexi glass, I am concerned about the heat warping the flange and leaking.

If that happened to me I don't think I could drink anything out of a can ever again.

Durham Missouri

I'd invent the plexican so I can see Moca Mouse before I drink him again.



Lawrenceville, GA

Straightened the left side intake manifold flange to minimize the coolant consumption.


Hyvinkää, FI

Been putting this off to do outside because of aluminum dust .  It was cold but had to start  so I can be running as warm weather here sooner than we think. Smoothed up the rough aluminum castings for 4-71 Blower case and bearing covers. Got a lot done  but still a ways to go before I will try to polish.  I've been putting off all winter but I now have all the parts to complete except for carb or fuel inj [???]..  Back at it today

Mars , Pennsylvania