I bought some all brass wire bullets to repair a couple of male end wires.  Is there a special brand of criimper  that is good?  I have been reading that you would crimp the narrow part of the bullet then soulder through the top? 

Appreciate the advice. 

Thanks

I like the kind that leaves a dimple in one side of the crimp. I find them pretty much "bullet proof" LOL. I have an old crimper that does this and I use it whenever I'm doing electrical work. I have had almost zero problems with wires coming out of the end. I never have used solder either, unnecessary in my opinion.

54 Victoria 312;  48 Ford Conv 302, 56 Bird 312
Forever Ford
Midland Park, NJ

Thanks for the reply.  Do you know the brand of crimper you used?

Thanks.

I use one from MSD which has replaceable dies for various types of connectors. It's great.


Lawrenceville, GA

Thanks for the info.  I will look them up.