I am dropping a 312 crank into a 292 block and have only started with the crankshaft. Obviously I need the ECZ or C1TE rods. This is not a race motor, but a good street engine. I live in Winchester, Virginia, right off I-81.

danaxjessup@yahoo.com

Daniel Jessup

Lancaster, California

aka "The Hot Rod Reverend"
check out the 1955 Ford Fairlane build at www.hotrodreverend.com

Daniel, I have a couple of sets of ECZ rods, might give up one set if you don't find any closer to you. I also have a set of used .060 pistons that are in good shape.

Glen Henderson



Freedom is not Free

Letohatchee, AL

thanks.

I believe I have already found a set.

Dan

Daniel Jessup

Lancaster, California

aka "The Hot Rod Reverend"
check out the 1955 Ford Fairlane build at www.hotrodreverend.com

Glen,

I may be interested in the pistons.  How much are you asking for them?

Butch Lawson

Butch Lawson

Manchester,  TN

Butch, how about $50.00. I pulled them from a 312 that was getting a little water in the oil, so the guy pulled it and put in a 292. They look pretty good, but I have not measured them for wear.

Glen Henderson



Freedom is not Free

Letohatchee, AL

Glen,

I sent you an e-mail about the pistons.

Butch Lawson

Manchester,  TN

Butch, the spam blocker must have got you, sorry. Try again glendebh@hughes.net or call 334-227-3004 or cell 334-799-6577. I will be on the road today, but the wife and I are spending Christmas at home this year so fill free to call any time.  Merry Christmas to all and lets all remember our troops.

Glen Henderson



Freedom is not Free

Letohatchee, AL