Welded stroker crank

Posted By RB 4 Months Ago

You don't have permission to rate!

Author	Message
RB	Posted 4 Months Ago
Supercharged Group: Forum Members Last Active: Last Month Posts: 662, Visits: 16.7K	Going to 3.75 stroke and a Honda bearing. Thought I would go this route instead of Billet. https://www.facebook.com/reel/2071943183372296/
	Reply Quote

Threaded View

Welded stroker crank By RB ( 4 Months Ago )

I went 3.60 with a 292 crank, and used a 1.850 bearing (CB 1664 H),... By Cliff ( 4 Months Ago )

Think i read somewhere that going under sizing can cause oiling... By Litshoot ( 4 Months Ago )

SBC 2.000” and Honda 1.889” (and smaller) journals helps with the... By Ted ( 4 Months Ago )

Ted I think you remember Adney Brown form Engine masters? I asked... By RB ( 4 Months Ago )

Cast or steel crankshaft? By 55blacktie ( 4 Months Ago )

As a general rule, welding to increase the stroke is typically... By Ted ( 4 Months Ago )

Final results on the welded stroker.. yes, it was a steel truck... By RB ( 4 Months Ago )

Nice, if you don't mind roughly how much did it cost to get done? By Litshoot ( 4 Months Ago )