Block Milling Limit

Posted By Carefree Charlie Last Year

You don't have permission to rate!

Block Milling Limit

Author	Message
Carefree Charlie	Posted Last Year
Supercharged Group: Forum Members Last Active: Last Year Posts: 31, Visits: 22.8K	I have a 292 block that looks clean. I do not know if it has milled at any time in the past. What is the limit for milling the head surface and where should it be measured to determine if it is within limits? block limits milling
	Reply Quote

Threaded View

Threaded View

Forum Post

Block Milling Limit By Carefree Charlie ( Last Year )

Forum Post

The nominal deck height is 9.775. Ted Eaton routinely surfaces the... By 55blacktie ( Last Year )

Forum Post

Is there a minimum thickness for the deck itself to measure with sonic... By Litshoot ( Last Year )

Forum Post

Good question. Zero-decking the block is not uncommon, but the... By 55blacktie ( Last Year )

Forum Post

If you look on the exhaust side, near the spark-plug holes, you'll... By 55blacktie ( Last Year )

Forum Post

The Y block has successfully been milled to 9.740" deck height and... By Joe-JDC ( Last Year )

Forum Post

You have to consider that anything that is mass-produced will not be... By 55blacktie ( Last Year )

Forum Post

Thank you for the help. Deck height looks okay based on the 9.7 I... By Carefree Charlie ( Last Year )

Forum Post

But is it square? If it isn't square or the surface smooth, you might... By 55blacktie ( Last Year )

Forum Post

The decks are reasonably thick but the intake manifold fitting... By Ted ( Last Year )

Forum Post

Thanks Ted and everyone for the comprehensive explanation regarding... By FORD DEARBORN ( Last Year )

Forum Post

If your pistons are .010, and your head gaskets have a compressed... By 55blacktie ( Last Year )

Forum Post

If i remember reading the teds article correct you take the distance... By Litshoot ( Last Year )

Reading This Topic