I might still have those push rods. I did check the deck to piston numbers, all within .001. I don’t think much was taken off the heads

Hi, Richard. 

Do you remember what length pushrods you used with those heads and the 1.6-ratio Rocker Arms Unlimited rocker arms? Was the block zero-decked? How much were heads milled?

Thanks. 

If you haven't done so already, you might want to post parts on the Facebook Y-block forum. I mentioned your heads there a couple of weeks ago and suggested checking this site for them, but your post had been removed. 

Bump

LOCATION SAN LUIS OBISPO CALIFORNIA 93405
PLESAE EMAIL ME FOR PHOTOS AND QUESTIONS. PRICES ARE FIRM AND DO NOT INCLUDE SHIPPING. I WILL PACAGE AND SHIP AT YOUR REQUEST.

ECG MUMMERT POCKET PORTED HEADS, VALVE JOB, VERY LOW MILAGE, 1000 IF THAT, COMES WITH DOCUMENTATION, ARP HARDWARE, TIN THUNDER BIRD VALVE COVERS, AND NEW SPARK PLUGS $1400.00

COIL MOUTING BRACKETS, I HAVE TWO. $30 EACH OR $50 FOR BOTH

1952/54 FORD NOS BACK UP LIGHT KIT, PRETTY SURE ITS COMPLETE, NO INSTRUCTIONS $225.00

1952/54 FORD NOS REMOTE OUSIDE MIRROR KIT, PRETTY SURE ITS COMPLETE $150.00

1953 FORD NOS REAR FENDER MOLDING. FITS ON THE FENDER BULGE $95.00

1952/54 NOS FENDER SKERTS WITH RUBBER MOLDING AND HARDWARE. $350.00

THERMOSTAT HOUSING $30.00.

THANK YOU,

RICHARD