Working on my 292 project i have a Howards cam #290862-10
How do you think it will work in my combo?
fenderless truck hot rod will weigh 2700lbs?
ford 8.8 with  4.10 posi rear
T5 trans
292 engine .040 over, zero deck flat top piston's with felpro or best head gaskets
c2ae rods with arp bolts
Main studs with windsor windage tray deep sump pan , chopped up a  scruby sb deep  wide sump pan .Fitted sump to y block truck pan, modified pickup for  3/8" clearance from bottom of pan, holds 8 qts.
gerotor oil pump new
Heads are CT1E  will be fully ported , milled to 70cc chambers. Will  have manley stainless 1.85 intake and 1.55 exhaust valves installed 
comp cams springs and hardware 
Static compression ratio should be 8.7:1 to 8.8:1 ?
Intake is edelbrock 257 ported per Joe Craines advice will use holley 2x4 sniper fuel injection
MSD ignition
Headers into flowmaster mufflers
camshaft is 238 @ .050" I &E
lift is .350" lobe lift, rockers are Barker ,Approx. 1.5 ratio lash is .022" 
valve lift should be approx..507" at valve with .018" hot lash 
will check for piston to valve clearance .
Would this run on pump gas  regular  or premium?
going to be a fun street rod to play with on weekends .

thanks for the info 55blacktie
It shows dynamic compression at 7.24:1