Hi!  i am collecting parts for a 292 build for a light weight fenderless truck, 5 speed manual   hot rod. I just picked up a set of new Barkers rocker arms for the intakes. does anyone have info on them such as ratio , quality ? 

Got a picture?

Lorena, Texas (South of Waco)

Thanks Ted
 

 

I don't know anything about them but I find it interesting. I'm not familiar with the company, I lived in Glendale from 1959-1969 just a few blocks from the address. I had no idea someone made HI LIFT rockers, but looking at the paper work it says Glendale 4, thats pre ZIP code so these are really early pieces.

Hi, look at my dragster engine build on this forum, I am using a set of these, also I've been selling these on E Bay for some time.

actually that's where i bought these from.

For the rocker ratio, this was a crude way to do it but I printed out the picture and simply measured from the shaft center hole to the estimated outside contact points.  I came up with a 1.53:1 rocker ratio.  Part of the ambiguity in doing this was in estimating where the rocker adjuster stud was going to be.

Lorena, Texas (South of Waco)

1.53:1 rocker ratio
So, not as "high lift" as stock 1957 rockers?

"FREE SAMPLE"

thanks Ted. 
I am still ahead because they are better then my galled up  1.43s, and cheaper than new 1.54s

Those rockers are for intake and exhaust or if you want intake only.