Anyone have a new set of 40 over 312 pistons they want to sell? I need to clean up a 30 over block that won't take a bigge bore. Chuck in NH

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

I am not sure but I read someplace that a Ford 3.8 oversize piston is very close to a 312 40 oversize.

Thanks, I'll look into that. Chuck in NH

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

on those 3.8 ford pistons , they measure  in MM's  , also you sport for set plus 2 , I believe they are press pin too, but over sizes are real close, use .912 pin , not sure on comp ht.

Po ol Davie

Sparta , Tn.

Chuck.  Have you tried Verne Schumann for the pistons?

Schumann’s Sales & Service, ph:563-381-2416

Lorena, Texas (South of Waco)

No I havn't. I wanted to see if anyone had a set on their shelf first. Lots of pistons sitting around out there. I have several sets but none are 40 over 312. The block I'm working on is too thin to go any bigger so I'm looking for a quickfix. It has a little pitting in one hole. Thanks for looking. Chuck in NH

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

Chuck: Just a thought, what about sleeving the bad cylinder, & reboring it, allowing you to use the pistons you have?.. ( from near Vancouver B.C.)

Paul