I have just reintalled the Fordomatic in my Aust 58 Customline with a 272 and there is a bracket that slips over the dipstick tube to brace it, but I cannot see anywhere for it to bolt to.

It is about 3 inches long and has a angled flat section with a 3/8 hole.

It doesn't line up with anything like the starter or manifold or head that I can see.

Help please for a dumbass with a short memory that can't remember where it was unbolted from

Gary - 1958 Star Customline and 1940 Ford Deluxe Hotrod

It lines up with the upper, passenger side, bell housing bolt. Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

chucks right as usual but its our drivers side bell housing bolt

moz. geelong victoria australia.

graduate 1980, bus, truck, car, hot rod, boat, submarine, hovercraft, hydrafoil, firetruck, mobile home, jet, helicopter, cruise ship, motorcycle, bicycle, santa's sleigh, clock, alloy bullbar, alloy fuel tank, lens, dr who's tardis, matter - anti matter warp drive buffer & y-block lover

Gee didn't realize snowcone was from OZ! Chuck

Y's guys rule!
Looking for McCullouch VS57 brackets and parts. Also looking for 28 Chrysler series 72 parts. And early Hemi parts.

MoonShadow, 292 w/McCulloch, 28 Chrysler Roadster, 354 Hemi)
Manchester, New Hampshire

If your bracket won't line up with any bolts, try slipping it up off the tube and turning it over.  It has weird angles that get even weirder when the bracket is upside down.

John - "The Hoosier Hurricane"